TB 1-1520-238-30-16
Figure 4. Main Landing Gear Fuselage Fairing Rework
(5) Replace main landing gear shock strut upper rod ends.
(a) Remove main landing gear shock strut upper rod ends (TM 1-1520-238-23) and install new (P/N
1168104-103) rod ends from modification kit using removed hardware (TM 1-1520-238-23).
NOTE
Do not remove existing identification plates.
(b) Apply existing serial number from modified shock strut to new identification plate (P/N
MS27253-F1) from modification kit. Also apply the following data to new ID plate. Use metal
stamping die set (TM 1-1520-238-23).
Part No.
Before Mod.
After Mod.
7-311210100-1
7-511210150-1
7-311210100-2
7-511210150-2
7-311210100-3
7-511210150-3
7-311210100-4
7-511210150-4
(c) Install annotated ID plate on shock strut next to existing ID plate (TM 1-1520-238-23).
(6) Install both modified main landing gear shock struts.
CAUTION
Failure to properly install the HS5975-02 washer could damage the mount and/or
the washer.
(a) Install struts using new washers (HS5975-02) with the chamfered side toward the mount, new
washers (P/N 7-111412031-13) and new nuts (P/N MS21025-28) from modification kit. See
6