TM 1-1520-238-23
5-281
5.65.
TAIL ROTOR TEETER STOP BUMPER REPLACEMENT continued
b. Check teeter stop for corrosion (para 1.49).
(1) Maximum depth not to exceed 0.010 INCH.
c. Check teeter stop and tail rotor fork for
cracks. None allowed.
5.65.6. Installation
CAUTION
To ensure bonding of bumper to teeter
stop. Temperature must be 69 F (20 C)
or higher in area where adhesive is mixed
and applied. Adhesive must be used
within 40 MINUTES from time of mixing.
a. Apply adhesive to bumper (1) and teeter stop
(2).
(1) Wipe teeter stop (2) clean. Use cloth
(item 52, App F)
(2) Apply a thin coat of adhesive to teeter stop (2)
and inner surface of bumper (1). Use
adhesive (item 3, App F) and brush (item 34,
App F).
b. Install bumper (1) on teeter stop (2).
(1) No additional pressure is required other than
that needed to hold bumper (1) in position.
c. Allow adhesive to cure for 24 HOURS at ambi-
ent temperature.
d. Inspect (QA).
END OF TASK
M04-259-3
2
1