TM 1-1520-238-23
4-397
4.124.
NO. 1 AND NO. 2 ENGINE SECONDARY NOZZLE UPPER SUPPORT STRUT AND CLEVIS
REMOVAL/INSTALLATION continued
NOTE
Sloped side of strut must face up.
b. Install strut (1) on struts (8) and (9) and nozzle
(10).
(1) Aline strut (1) over struts (8) and (9) and
nozzle (10) as shown.
(2) Install bolt (11) and washer (12).
c. Adjust clevis (6).
(1) Aline clevis (6) over lug (7).
(2) Install pin (5) through washer (4), clevis (6),
and lug (7). If pin (5) can be installed go to
step d. If not, remove pin (5) and perform step
c(3).
(3) Turn clevis (6) into or out of strut (1) until pin
holes in clevis (6) and lug (7) can be alined
without forcing. Then repeat step c(2).
d. Install strut (1) on fairing (2).
(1) Install new cotter pin (3) through pin (5).
e. Tighten bolt (11) on strut (1).
f. Tighten clevis nut (13).
(1) Hold clevis (6).
g. Lockwire nut (13) to clevis (6). Use wire
(item 226, App F).
h. Inspect (QA).
END OF TASK
1
2
M04-2612-5
1
89
12
10
11
7
3
6
5
13
4