Change 6 9-102.1
AC GENERATOR NO. 2 REMOVAL/INSTALLATION continued
If alinement pin on transmission is not
properly alined with the hole in genera-
tor, generator and/or transmission
may be damaged. Ensure alinement
pin is in hole and generator is flush
against transmission before torquing
quick attach assembly (QAA).
Dropping generator or striking genera-
tor spline will cause internal bearing
damage resulting in premature failure.
Ensure generator tool flip shim is in
FWD position for AH64A aircraft gen-
a. Place tool flip shim in FWD position.
b. Place generator (2) on tool Use generator
c. Install generator (2) on transmission (17).
(1) Position QAA (14) so that gap in QAA is cen-
tered with alinement pin (18).
Ensure that drive spline adapter is
installed in main transmission before
(2) Position generator (2) so that hole (19) is
alined with alinement pin (18).
(3) Insert generator spline (20) in transmission
drive spline adapter (16).
GO TO NEXT PAGE