TM 1-1520-238-23
9-342
Change 1
9.94.
TAIL OR WING NAVIGATION LIGHT INSTALLATION continued
a. Install clinch nut (1) between plate (2) and
light base (3).
b. Install nut (4) on base (3).
(1) Install nut (4) with spring (5) on base (3).
c. Install base (3) in wing tip (6). Torque screw (7)
to 64 INCH-OUNCES.
(1) Position base (3) on wing tip (6).
(2) Install three screws (8) through washers (9),
plate (2), and wing tip (6).
(3) Place gasket (10) and lens (11) in base (3).
(4) Install screw (7) through two washers (12),
lens (11), plate (2), base (3) in wing tip (6).
(5) Torque screw (7) to 64 INCH-OUNCES. Use
screwdriver bit and torque wrench.
d. Perform
electrical
bond
check
(TM 55-1500-323-24).
(1) Bond shall be 0.1 OHM or less. Use
ohmmeter.
e. Inspect (QA).
GO TO NEXT PAGE
9
M04-1246-2
11
12
10
6
8
1
3
7
2
4
5
8
9
3
6
2