TM 1-1520-238-23
9-497
9.132.
PILOT W220 OR CPG W219 MICROPHONE WIRE HARNESS
DISASSEMBLY/ASSEMBLY continued
CAUTION
Do not allow heat shrink to slide over
braided shield when installing solder
sleeves.
f. Install two solder sleeves (33) on twisted pairs
(13) and (19).
(1) Slide two solder sleeves (33) over twisted
pairs (13) and (19).
(2) Shrink solder sleeves (33) and insulation
sleeving (item 102, App F) (32) on twisted
pairs (13) and (19) (TM 55-1500-323-24).
NOTE
The following steps are typical for all six
electrical contacts.
g. Install electrical contacts (34) on harness (2).
(1) Cut wire (3) at base of damaged contact (34).
(2) Strip 0.09 INCH of insulation off wire (3).
(3) Install contact (34) on wire (3) and crimp
(TM 55-1500-323-24).
GO TO NEXT PAGE
M04-4235-19
32
33
19
13
M04-4235-20
3
34
2