TM 1-1520-238-23
15-168
Change 3
15.43.
APU ENCLOSURE SUPPORT BRACKETS REMOVAL/INSTALLATION - continued
c. Install support brackets (3) on support assem-
bly (2).
(1) Lightly wipe mating surfaces of bracket (3)
and support assembly (2). Use methyl ethyl
ketone (item 124, App F) and clean rag.
(2) Position enclosure panel (10). Install two fas-
teners (11) in two brackets (3).
(3) Mark position of bracket (3) on support (2).
Do not use mating surfaces.
(4) Remove fasteners (11) from brackets (3). Re-
move panel (10).
(5) Spread a thin, uniform layer of adhesive on
mating surfaces. Use adhesive (item 3,
App F) and depressor (item 70, App F).
(6) Aline bracket (3) with position marks on sup-
port (2). Press together and clamp in place.
Use C clamp.
(7) Cure adhesive 1 HOUR minimum at 190 to
210 F (87 to 98 C). Use heater. Wear
protective gloves.
(8) Remove C clamp.
GO TO NEXT PAGE
11
10
3
2
M04-2838-8
3