TAIL LANDING GEAR WHEEL (WITHOUT GREASE FITTING) REPAIR (AVIM)

TAIL LANDING GEAR WHEEL (WITHOUT GREASE FITTING) REPAIR (AVIM) continued - TM-1-1520-238-23-2_1070

TAIL LANDING GEAR TAPERED CONE AND ROLLERS PACKING

TM-1-1520-238-23-2 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual
Page Navigation
1037

TM 1-1520-238-23 Change 6 3-190.5/(3-190.6 blank) 3.51A. TAIL LANDING GEAR WHEEL (WITHOUT GREASE FITTING) REPAIR (AVIM) 3.51A.8. Installation b. Install tail landing gear wheel tapered roller cups (TM 55-1500-322-24). b. Paint tail landing gear wheels (2). (1) Apply corrosion resistant coating to wheel halves and allow to dry for minimum ONE HOUR at a minimum temperature of 65 F (18 C). Use corrosion resistant coating (item 66, App F). NOTE Apply primer to male/female mating surfaces and bolt bosses only. (2) Apply primer to wheels (2). Use epoxy primer coating kit (item 78, App F) (TM 55-1500-345-23). (3) Apply paint to wheels (2). Use polyurethane coating (item 141, App F) (TM 55-1500-345-23). NOTE If wheel is not installed on helicopter, rollers shall be protected (TM 55-1500-322-24). f. Install tail landing gear wheel tire and tube (para 3.50). g. Install tail landing gear wheel tapered cones and rollers (para 3.51). h. Install tail landing gear wheel and axle (para 3.49). i. Inspect (QA). END OF TASK

Privacy Statement
Press Release
Contact