TM 1-1520-238-23
Change 8
2-419
2.115.
HORIZONTAL STABILATOR DEBRIS COVER REMOVAL/INSTALLATION
2.115.1. Description
This task covers:
Removal. Cleaning. Inspection. Installation.
2.115.2. Initial Setup
Tools:
Aircraft mechanic’s tool kit (item 376, App H)
Light duty laboratory apron (item 27, App H)
Chemical protective gloves (item 154, App H)
Adjustable air filtering respirator (item 262, App H)
2-inch wide hand roller (item 270, App H)
Materials/Parts:
Cover, Debris Protection-Stabilator (figure D442.9 and/
or D-442.10, App D)
Adhesive (item 13, App F)
Isopropyl alcohol (item 106, App F)
Methyl ethyl ketone (item 124, App F)
Paper (item 135, App F)
Primer, Pressure Sensitive Tape (item 144A, App F)
Tape (item 206, App F)
Personnel Required:
67R
Attack Helicopter Repairer
One person to assist
67R3F
Attack Helicopter Repairer/Technical
Inspector
References:
TM 55-1500-345-23
Equipment Conditions:
Ref
Condition
1.57
Helicopter safed
2.2
Access panel L548 or R548 removed
NOTE
This task is typical for left and/or right
debris cover.
2.115.3. Removal
a. Remove debris cover (1) from horizontal sta-
bilator (2).
(1) Mask off area around debris cover (1). Use
tape (item 206, App F).
(2) Loosen cover (1) by applying solvent to
edges.
(a) If cover is a double ply cover, use
isopropyl alcohol (item 106, App F).
(b) If cover is a single ply cover, use methyl
ethyl ketone (item 124, App F).
GO TO NEXT PAGE
M04-3629-1
1
2
M04-3629-4A
