TM 1-1520-238-23
4-332
4.101.
NO. 1 OR NO. 2 ENGINE OIL CHIP COLLECTOR REMOVAL/INSTALLATION – continued
4.101.4. Cleaning
a. Clean collector boss on sump (para 1.47).
4.101.5. Inspection
a. Check sump for corrosion (para 1.49).
4.101.6. Installation
a. Install collector (2) in oil sump (3). Torque col-
lector (2) to 130 INCH-POUNDS.
(1) Install washer (5) on sump (3).
(a) Apply sealant to washer (5) on side oppo-
site the countersink. Use adhesive
(item 14, App F).
(b) With countersink facing out, aline hole in
washer (5) with collector (2) mounting
hole. Press in place. Wipe excess sealant
with a clean dry rag.
(2) Install new packing (4) on collector (2).
(a) Lubricate packing (4). Use lubricating oil
(item 119, App F).
(b) Install packing (4) in collector groove (6).
(3) Torque collector (2) to 130 INCH-POUNDS.
Use crowfoot and torque wrench.
NOTE
Probe is properly installed when knurl tips
and hex points aline.
b. Install probe (1) in collector (2).
(1) Push and turn probe clockwise.
GO TO NEXT PAGE
2
M04-2549-4
3
5
4
1
2
M04-2549-3
1
4
3
6
2
