TM 1-1520-238-23
Change 1
11-921
11.213.
PILOT LATERAL CONTROL POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER (LVDT)
INSTALLATION – continued
e. Install LVDT (2) on bracket (13). Torque nut (14)
14 to 18 INCH-POUNDS.
(1) Aline LVDT (2) with bracket (13).
(2) Install bushing (15) in bracket (13).
(3) Install bolt (16) through bushing (15), rod end
(10), and bracket (13).
(4) Check fit of self-retaining bolt (16) (para
11.1).
(5) Install nut (14). Torque nut (14) to 14 INCH-
POUNDS. Use torque wrench.
(6) Increase torque to aline cotter pin hole, but do
not exceed 18 INCH-POUNDS.
(7) Install new cotter pin (17).
f. Install pilot cyclic stick -5 rig pin (para 11.289).
g. Attach connector P233 (8) to receptacle J233
(18).
h. Install two clamps (19) on wire harness (9).
(1) Install two screws (20) through washers (21)
and clamps (19).
i. Install lead (5) on ground stud (22).
(1) Install washer (23) and nut (24).
GO TO NEXT PAGE
M04-1862-3A
17
14
13
2
16
10
15
M04-1862-4
20
21
19
22
23
24
20
21
19
9
8
18
5
