TM 1-1520-238-23
12-99
12.32.
MAIN DECK FIRE/OVERHEAT DETECTOR REMOVAL/INSTALLATION - continued
12.32.3. Removal
CAUTION
Do not damage sensing element during
removal. Damage may occur when bend-
ing the element. A minimum bend radius
of 0.375 INCH shall be maintained to
minimize possible damage.
a. Remove fire/overheat detector (1) from sup-
port (2).
(1) Detach connector P1322 (3) from receptacle
(A699)J1 (4).
(2) Remove two nuts (5), washers (6), screws
(7), clamps (8), and spacers (9).
(3) Remove fire sensing element (10) from 24
spring tension clips (11).
NOTE
If spring tension clips do not require
replacement, go to paragraph 12.32.4.
Step b applies to all 24 spring tension
clips.
b. Remove spring tension clip (11) from clamp
(12).
(1) Remove nut (13), washer (14), and screw
(15).
(2) Remove and discard clip (11).
GO TO NEXT PAGE
M04-3508-2
7
10
4
8
9
8
3
1
2
6
5
9
M04-3508-3
12
10
14
15
11
13
