TM 1-1520-238-23 Change 4 D-47 Table D-18. Continuous Hinge PN MS20257 Dash number Pin Diameter Width Length Notes P3-450 0.090 1.250 4.50 1, 2, 4 C4-350 0.090 1.500 3.50 1, 3, 4 P4-1056 0.090 1.500 10.56 1, 2, 4 P4-1425 0.090 1.500 14.25 1, 2, 4 P4-2500 0.090 1.500 25.00 1, 2, 4 P4-2650 0.090 1.500 26.50 1, 2, 4 P4-3250 0.090 1.500 32.50 1, 2, 4 NOTES: 1. All dimensions in inches 2. Make from anodized AL-ALY, MIL-A-8625, TY2, NSN 5340-00-051-9133 3. Make from unanodized corrosion resistant steel NSN 5340-00-173-8177 4. Cut to length Table D-19. Grommet PN MS21266 Dash number Sheet Thickness Notes -1N 0.015-0.052 1, 2, 5 -1T 0.015-0.052 1, 3, 5 -2N 0.052-0.085 1, 4, 5 NOTES: 1. All dimensions in inches 2. Make from nylon plastic edging material, MIL-M-20693, TY1, NSN 5325-00-220-5576 3. Make from polytetrafluoroethylene (TFE) edging material, L-P-403, TY1, NSN 5325-00-714-3261 4. Make from nylon plastic edging material, MIL-M-20693, TY1, NSN 5325-00-074-3301 5. Cut to size Table D-20. Seal PN ZZ-R-765 Dash number Thickness Length Notes -7 0.062 Cut to size 1, 2 -9 0.062 Cut to size 1, 2 NOTES: 1. All dimensions in inches 2. Make from silicone rubber sheet, PN ZZ-R-765, CL2, GR50, NSN 9320-00-202-1322