TM 1-1520-238-23 D-111 NOTES: 1 BRACKET, FRONT PANEL SUPPORT - MAKE FROM AL-ALY 6061-0 0.063 THICK, QQ-A-250-11 NSN 9535-01-361-8000 2 WELD BOTTOM CORNERS AS SHOWN (2 PLACES) WELD FILLET TO BE 0.015 TO NONINTERFERENCE WITH HARDWARE, BOTTOM AND SIDE SURFACES MUST BE MACHINED FLUSH AFTER WELDING 3 HEAT TREAT TO T6 AFTER WELDING 4 FINISH - CONVERSION COAT PER MIL-C-5541, CLASS 3, COLOR YELLOW, FORM 2 METHOD B NSN 8030-01-018-2838 5 ALL DIMENSIONS ARE IN INCHES SEE DETAIL A 0.36 ± 0.01 SEE NOTE 2 2 PL G 0.201 DIA 2 HOLES 0.12 ± 0.03 0.0100 A 1.12 ± 0.01 -A- 0.43 ± 0.01 0.156 ± 0.001 DIA 2 HOLES DETAIL A SCALE: NONE TYPICAL 2 PL CORNER TO CORNER TO 0.015 0.250 1.06 0.50 0.25 FULL R 0.187 R 0.437 0.500 0.50 ± 0.01 M04-4572 Figure D-17. Bracket, Front Panel PN 62023078-000 M04-4573 NOTES: 1 BRACKET, REAR PANEL SUPPORT - MAKE FROM AL-ALY SHEET 6061-0 QQ-A-250/11, 0.063 THICK, NSN 9535-01-361-8000 2 WELD CORNERS AS SHOWN (2 PLACES). WELD FILLET TO BE 0.015 TO NONINTERFERENCE WITH HARDWARE. BOTTOM AND SIDE SEE DETAIL A 0.037 ± 0.01 NOTE 2 2 PL G 0.210^+0.005 -0.002^DIA 1 HOLE 0.45 ± 0.01 0.75 0.75 0.09 ± 0.03 0.10 ± 0.03 0.0100 A -A- 0.156 ± 0.006 DIA HOLE CORNER TO CORNER TO 0.015 0.37 0.44 0.74 0.88 DETAIL A SCALE: NONE TYPICAL 2 PL Figure D-18. Bracket, Rear Panel PN 62023079-000