TM 1-1520-238-T-4
Change 5
689
629.
TEMP INT INDICATOR LIGHTS
629
Tools:
Nomenclature
Part Number
Tool Kit, Electrical
SC518099CLA06
Repairers
Multimeter, Digital
AN/PSM-45
Personnel Required:
68X
Armament/Electrical Systems Repairer
One person to assist
References:
TM 1-1520-238-T-6
TM 1-1520-238-23
Equipment Conditions:
Ref
Condition
TM 1-1520-238-23
Access provisions
L200, R295, L510,
R510, L545, and
R545 access doors
open
WARNING
Turn off power before detaching or
attaching wires and connectors. High
current 28 VDC or 115 VAC is present.
Failure to do so could result in death or
serious injury.
1. Detach P200.
Does TEMP INT indicator remain lighted?
YES
Go to step 3.
NO
Go to step 2.
2. Check resistance between P200U and P200c.
Is resistance greater than 1 megohm?
YES
Go to step 4.
NO
Replace IGB temperature alarm.
3. Check for short between P1826 and ground.
Does short exist?
YES
Repair shorted wire between:
P914A9 and ground,
J449A19 and ground,
J410B14 and ground,
P200c and ground.
Go to paragraph 612.
NO
Refer to TM 1-1520-238-T-6 to
troubleshoot the pilot
caution/warning system.
4. Remove IGB thermistor probe RT14
(TM 1-1520-238-23). Check resistance between
P200C and P200S.
Is resistance greater than 32k ohms?
YES
Go to step 6.
NO
Go to step 5.
5. Check resistance between P1249 and
P12410.
Is resistance greater than 32k ohms?
YES
Repair wire to wire short
between:
P200C and J1249,
P200A and J12411,
P200K and J12413,
P200E and J12415.
Go to paragraph 612.
NO
Replace IGB thermistor probe
RT14 (TM 1-1520-238-23).
6. Remove IGB thermistor probe RT13
(TM 1-1520-238-23). Check resistance between
P200A and P200S.
Is resistance greater than 32k ohms?
YES
Go to step 8.
NO
Go to step 7.