TM 1-1520-238-T-5
7–62
7–10.
PRIMARY HYDRAULIC SYSTEM – MAINTENANCE OPERATIONAL CHECK (cont)
7–10
Task
Result
m. Have assistant measure and record cylinder
stroke. Use inside calipers. Measurement A
is from bottom of jam nut to top surface of
servocylinder housing (cylinder retracted)
(fig. 7–31).
DISTANCE
MEASURED
BOTTOM OF
JAM NUT
PISTON
TOP SURFACE OF
SERVOCYLINDER
HOUSING
M68-016
Figure 7–31.
Servocylinder (Typical)
n. Slowly pull pilot cyclic stick to full aft position
to extend piston.
o. Have assistant measure and record cylinder
stroke. Use inside calipers. Measurement B
is from bottom of jam nut to top surface of
servocylinder housing (cylinder extended).
p. Subtract measurement A from B. Cylinder
travel is 3.500 to 3.560 inches.
If cylinder does not travel full stroke, go to step af.
q. Slowly pull pilot collective stick to full up
position to retract collective servocylinder
piston.
r. Have assistant measure and record cylinder
stroke. Use inside calipers. Measurement A
is from bottom of jam nut to top surface of
servocylinder housing (cylinder retracted).
