GUN AND AMMO SUPPORT AFT MOUNT PADS SLEEVE BUSHING REPLACEMENT
a. Clean bushing bore. Use methyl ethyl ketone (item 124, App F), naphtha (item 127, App F), or thinner
(item 211, App F), and cloth (item 52, App F) (para 1.47).
a. Check support bushing bore for cracks. None allowed.
b. Check support bushing bore for scoring, nicks, and scratches.
c. Scoring, nicks, and scratches are acceptable if less than 0.025 INCH deep.
d. Check support surface for corrosion (para 1.49).
e. Check support bushing bore diameter.
(1) Maximum allowable diameter 0.5000 INCH.
Do not place heater near flammable material or allow heater to contact skin: severe burns can
result. Wear protective equipment. If injury occurs, seek medical aid.
Do not heat bushing bore area over 200 F (98 C) or damage may result.
Do not allow primer or paint to enter bushing bore or bushing damage may result.
GO TO NEXT PAGE