TM 1-1520-238-23
Change 1
2-285
2.82.
AMMUNITION MAGAZINE STRUT AND EYE BOLT REMOVAL/INSTALLATION – continued
2.82.6. Installation
a. Install eye bolt (7) on fitting (2).
(1) Install bolt (8) and washer (14) halfway
through fitting (2).
(2) Install eye bolt (7), washers (11), (12), and
(13) in fitting (2), then push bolt (8) fully
through hardware and fitting (2).
(3) Measure gap between washer (12) and fitting
(2), then add 0.015 INCH.
(4) Remove hardware installed in step a.(2).
(5) Peel washer (13) to thickness determined by
step a.(3).
(6) Apply adhesive to washer (13) and bond to
fitting (2). Use adhesive (item 2, App F).
(7) Install bolt (8) and washer (14) halfway
through fitting (2).
(8) Install eye bolt (7), washers (11) and (12) in
fitting (2), then push bolt (8) fully through fit-
ting (2).
(9) Install washer (10) and nut (9) on bolt (8).
b. Install strut (1) on fitting (2) and airframe (2.1).
(1) Aline strut (1) with attachment point (2) and
airframe (2.1).
(2) Install bolt (3) through washer (6), strut (1),
and washer (5) (two places).
(3) Install two nuts (4).
c. Install ammunition storage magazine
(TM 9-1090-208-23-1).
END OF TASK
8
2
9
1112
13
M04-2652-5
14
10
7
2
M04-2652-4A
4
5
6
3
1
2.1
