TM 1-1520-238-23
Change 9
3-9
3.2.
MAIN LANDING GEAR CABLE ASSEMBLY REPLACEMENT – continued
3.2.6. Installation
a. Install cable (3) on bracket (4).
(1) Install nut (2) on cable (3). Run down full
length of threads.
(2) Install cable (3) up through bracket (4).
(3) Install nut (1) on end of cable (3).
(4) Turn nut (1) until bottom of cable (3) touches
ground, then back off nut (1) 0.50 INCH.
(5) Run up nut (2) until cable (3) is secure.
b. Perform
electrical
bond
check
(TM 55-1500-323-24).
(1) Bond shall be 0.1 OHM or less. Use
ohmmeter.
c. Lockwire nuts (1) and (2) together. Use wire
(item 224, App F).
d. Apply sealing compound around base of nut
(1) and top of nut (2). Use sealing compound
(item 175, App F).
e. Inspect (QA).
END OF TASK
M04–606–4
4
1
2
3
