TM 1-1520-238-23
5-290
Change 5
5.67.
TAIL ROTOR FORK AND TEETER STOP DISASSEMBLY/ASSEMBLY (AVIM) continued
(4) Aline bolt holes of teeter stop (1) with aline-
ment rods (4) of fixture (3) and slide teeter
stop (1) onto fixture (3). Press and hold teeter
stop (1) firmly against mating surface of fork
(2).
(5) Install compression disk (6) on fixture (3) and
tighten bolt (5) until springs (7) are com-
pressed to approximately 50% of original
height.
c. Remove excessive adhesive squeezeout
along teeter stop/fork bondline. Use isopropyl
alcohol (item 106, App F) and cloth (item 50,
App F).
d. Allow adhesive to cure for a minimum of 24
HOURS at room temperature, or heat cure for
2 HOURS at 150 5 F (63 3 C).
e. Rinse teeter stop bondline and wipe dry. Use
distilled water (item 73, App F) and cloth
(item 52, App F).
f. Remove fixture (3) from fork (2).
(1) Loosen bolt (5).
(2) Remove compression disk (6) and fixture (3)
from fork (2).
h. Cut off excess monofilament line flush to
glue line.
i. Inspect (QA).
NOTE
If teeter stop was replaced, perform step
j. Otherwise, proceed directly to step k.
j. Install new teeter stop bumpers (para 5.65).
k. Install tail rotor hub (para 5.57A).
END OF TASK
M04-5195-3
5
3
7
1
4
2
6
5
M04-5195-4
2
3
6
5
