TM 1-1520-238-23
4-98
4.32.
ENGINE BUILDUP – NO. 1 OR NO. 2 ENGINE INSTALLATION ON HANDLING
ADAPTER – continued
(3) Aline mount (8) with support (9).
(4) Install pin (14) through mount (8) and support
(9).
(5) Loosen jam nuts (10) on adapter lower for-
ward support (11). Adjust support (11) to aline
with engine lower forward mount (12).
(6) Install pin (15) through support (11) and
mount (12). Tighten jam nuts (10).
(7) Loosen jam nuts (19) on adapter aft lower
support (20). Adjust support (20) to aline with
engine aft lower mount (21).
(8) Install pin (16) through support (20) and
mount (21). Tighten jam nuts (19).
(9) Lock pins (14), (15), and (16).
(a) Turn bolt (18) clockwise until lock (22)
engages with spring clip (17). Use torque
wrench.
(b) If torque required to lock pins (14), (15),
or (16) is not 55 to 100 INCH-POUNDS,
replace pin.
GO TO NEXT PAGE
14
M04-1349-11
9
8
M04-1349-12
15
12
11
10
M04-1349-14
20
19
19
21
16
17
22
18
M04-1349-15
ROTATED
FOR CLARITY
