TM 1-1520-238-23
Change 3
5-145
5.30.
MAIN ROTOR STRIKER PLATE REMOVAL/INSTALLATION – continued
5.30.6. Installation
a. Lubricate two bolts (4). Use lubricant (item 114,
App F).
(1) Allow lubricated bolts to cure for 6 HOURS at
room temperature, or air dry for 30 MINUTES
and then cure for 30 MINUTES at 150 F (66
C).
b. Install plate (1) and shims(s) (2) on housing
(3). Torque two bolts (4) to 285 INCH-POUNDS.
NOTE
Maximum number of shims is 9.
(1) Position shim(s) (2) and plate (1) on housing
(3) with holes alined.
(2) Install two washers (5) and bolts (4).
(3) Torque two bolts (4) to 285 INCH-POUNDS.
Use torque wrench.
(4) Lockwire two bolts (4) to housing (3). Use
wire (item 225, App F).
c. Remove droop stop wedges and release ten-
sion on lift cable lowering main rotor blade
(para 1.84).
d. Measure main rotor blade droop angle (para
5.10).
e. Remove maintenance crane (para 1.105).
f. Inspect (QA).
END OF TASK
M04-210-6
3
2
1
5
4
