TM 1-1520-238-23
7-445
7.116.
AIR PARTICLE SEPARATOR REMOVAL/INSTALLATION – continued
7.116.3. Removal
a. Remove tube (1) from union (2).
(1) Hold union (2). Remove nut (3).
(2) Remove tube (1) from union (2).
b. Slide sleeve (4) on inlet throttle valve (5).
(1) Remove two clamps (6).
(2) Slide sleeve (4) on valve (5).
c. Remove air particle separator (7).
(1) Remove sealant from four bolts (8), washers
(9), and from separator mounting area on up-
per fuselage fairing frame (10) (para 1.47).
(2) Remove four bolts (8) and washers (9).
(3) Lift separator (7) from frame (10) and sleeve
(4).
NOTE
If removing and replacing separator, go
to step d. If removing and reinstalling
separator, go to paragraph 7.116.4.
d. Remove union (2) from separator (7).
(1) Remove union (2) from separator (7).
(2) Remove and discard packing (11).
GO TO NEXT PAGE
M04-057-2
8
9
10
5
4
7
11
2
3
1
6
