TM 1-1520-238-23
7-452
7.117.
AIR PARTICLE SEPARATOR (WITH FILTER) REMOVAL/INSTALLATION – continued
7.117.6. Installation
NOTE
If separator was replaced, go to step a. If
not, go to step b.
a. Install union (2) on separator (7).
(1) Lubricate new packing (11). Use petrolatum
(item 138, App F).
(2) Install packing (11) on union (2).
(3) Install union (2) on separator (7).
b. Install separator (7).
(1) Position separator (7) in upper fuselage fair-
ing frame (10) while sliding large tube end
(12) into sleeve (4).
(2) Install four bolts (8) and washers (9).
(3) Slide sleeve (4) and two clamps (6) on tube
(12).
(4) Center sleeve (4). Tighten two clamps (6).
(5) Install sealant between separator (7) and
frame (10). Install sealant on four bolts (8)
and washers (9). Use sealing compound
(item 177, App F) and brush (item 34,
App F).
GO TO NEXT PAGE
M04-3760-3
8
9
2
4
6
12
7
11
10
M04-3760-4
7
8
9
10
