TM 1-1520-238-23
Change 8
6-322.3/(6-322.4 blank)
6.72A.
MAIN TRANSMISSION GENERATOR SPLINE CORK STOPPER REPLACEMENT – continued
6.72A.6. Installation
NOTE
Do not allow sealing compound to con-
tact splines.
Ensure tapered end of cork stopper is
inserted first.
a. Install cork stopper (3) in gearshaft (2).
(1) Apply sealing compound to perimeter mating
surface of cork stopper (3) and gearshaft at
the generator end (2). Use sealing compound
(item 163, App F).
(2) Install cork stopper (3) 2.12 – 2.38 INCHES
deep from outer face of gearshaft (2).
(3) Apply sealing compound to exposed surface
of the cork (3). and fillet. Use sealing
compound (item 163, App F).
(4) Allow sealing compound to cure 24 HOURS
at a minimum temperature of 65 F (18 C).
c. Inspect (QA).
END OF TASK
M04-5235-4
3
2
