TM 1-1520-238-23
Change 1
6-369
6.84.
HEAT EXCHANGER PRESSURE TRANSDUCER REMOVAL/INSTALLATION – continued
b. Install bracket (9).
(1) Install two screws (10) and washers (11).
c. For transducer (12) replacement, install new
contacts (15) (TM 55-1500-323-24).
(1) Cut wires (3), (4), and (5) to correct length.
(2) Install three new contacts (15) on wires (3),
(4), and (5).
d. Pin identified wires (3), (4), and (5) in connec-
tor (1) (TM 55-1500-323-24).
(1) Pin white wire (3) in connector hole 2.
(2) Pin black wire (4) in connector hole 3.
(3) Pin red wire (5) in connector hole 1.
e. Attach connector P579 (1) to receptacle J579
(2) for left side.
f. Attach connector P578 (1) to receptacle J578
(2) for right side.
g. Install clamp (6) on wires (3), (4), and (5).
(1) Position clamp (6) on wires (3), (4), and (5).
(2) Install screw (7) and washer (8).
h. Inspect (QA).
i. Service main transmission oil system (para
1.32).
j. Perform drive system maintenance operation-
al check (TM 1-1520-238-T).
k. Secure access doors T250L, T250R, T290L,
T290R, and L325 (para 2.2).
END OF TASK
M04-459-5
7
8
3
2
6
10
1
11
4
5
9
15
3
4
5
2
1
