TM 1-1520-238-23
7-162
Change 5
7.43.
COLLECTIVE SERVOCYLINDER ROD END REPLACEMENT – continued
7.43.3. Removal
WARNING
To prevent movement of bellcrank and
possible injury, support bellcrank be-
fore disconnecting servocylinder. If
injury occurs, seek medical aid.
CAUTION
To prevent damage to rigid hydraulic
tubes, ensure upper end of servocylinder
is supported when rod end is discon-
nected from the bellcrank.
a. Remove rod end (1) from bellcrank (2).
(1) Remove sealant from attaching hardware
(para 1.47).
(2) Remove and discard cotter pin (3).
(3) Hold self-retaining bolt (4). Use box wrench.
(4) Remove nut (5). Use crowfoot.
(5) Remove bolt (4) and washer(s) (4.1) if
installed.
NOTE
Do not remove nylon washer unless it is
loose or excessively worn.
(6) Remove bushing (6) and nylon washer (7) (if
necessary).
(7) Remove rod end (1) from bellcrank (2).
b. Measure and record distance A between cen-
ter of rod end bore (8) and top of piston rod
(9).
GO TO NEXT PAGE
M04-792-2A
5
3
2
4
1
4.1
7
1
2
6
M04-792-4A
A
1
8
9
M04-792-6
