TM 1-1520-238-23
11-41
11.4.
FLIGHT CONTROL SYSTEM BEARING/BUSHING REPLACEMENT (AVIM) – continued
c. Apply appropriate primer or sealing com-
pound around housing (2) and bearing/bush-
ing to form a fillet seal. Refer to Table 11-1
notes column.
d. Inspect (QA).
11.4.7. Installation (Temperature Differential Fit Meth-
od)
CAUTION
Do not freeze sealed bearings below -65
F (-53 C). Do not freeze all other bear-
ing(s)/bushing(s) below -321 F (-196
C).
a. Freeze bearing/bushing (1) in freezer at 0 F
(-18 C) or below for 3 hours or use carbon
dioxide (item 40, App F). Use carbon dioxide
(dry ice).
WARNING
Do not place heater near flammable
material or allow heater to contact
skin: severe burns can result. Wear
protective equipment. If injury occurs,
seek medical aid.
CAUTION
Do not heat ferrous parts over 350 F
(177 C) and nonferrous parts over 200
F (93 C).
b. If necessary, heat housing (2) mating bore.
Use heater.
GO TO NEXT PAGE
1
M04-4319-3
2
