TM 1-1520-238-23
11-387
11.87.
CPG TO PILOT LATERAL F.S. 65.50 CONTROL BRACKET ASSEMBLY
REMOVAL/INSTALLATION – continued
11.87.6. Installation
CAUTION
To prevent damage to flight control sys-
tem components, do not use force to
aline bellcrank with bracket or to aline
push-pull rod with bellcrank.
a. Install bellcrank (2) on bracket (14). Torque nut
(19) 30 to 40 INCH-POUNDS.
(1) Install spacer (24) and bearing (23) on bell-
crank (2).
(2) Aline bellcrank (2) with bracket (14).
(3) Install bolt (20) through washer (21), bushing
(22), bracket (14), and bellcrank (2).
(4) Check fit of self-retaining bolt (20) (para
11.1).
(5) Install nut (19). Torque nut (19) to 30 INCH-
POUNDS. Use torque wrench.
(6) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(7) Install new cotter pin (18).
b. Install bracket (14) on airframe (15).
(1) Aline bracket (14) on airframe (15).
(2) Install three bolts (16) through washers (17)
and bracket (14) into airframe (15).
GO TO NEXT PAGE
M04-4317-8
20
21
22
19
23
24
18
2
14
M04-4317-9
17
14
17
17
16
16
16
15
