TM 1-1520-238-23
11-619
11.139. COLLECTIVE F.S. 161.60 PUSH-PULL ROD ASSEMBLY REMOVAL/INSTALLATION – continued
11.139.4. Cleaning
a. Wipe removed and attaching parts with a
clean rag.
11.139.5. Inspection
a. Check removed and attaching parts for dam-
age (para 11.5).
b. Check removed and attaching parts for corro-
sion (para 1.49).
c. Check all installed bushing(s) and/or bear-
ing(s) for wear (para 11.5).
d. Check all removed bushing(s) and/or bear-
ing(s) for wear (para 11.4).
11.139.6. Installation
CAUTION
To prevent damage to flight control sys-
tem components, do not use force to
aline bellcrank with bracket or to aline
push-pull rod with bellcrank.
a. Install adjustable end of rod (6) on bellcrank
(13). Torque nut (15) 30 to 40 INCH-POUNDS.
(1) Aline rod (6) with bellcrank (13).
(2) Install bolt (16) through washer (17), bushing
(18), bellcrank (13), and rod (6).
(3) Check fit of self-retaining bolt (16) (para
11.1).
(4) Install nut (15). Torque nut (15) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (14).
GO TO NEXT PAGE
M04-4388-7
6
16
18
17
15
14
13
