TM 1-1520-238-23
11-1164
Change 3
11.275.
TAIL ROTOR DRIVE LINK INSTALLATION continued
d. Install link (1) on swashplate (17). Torque nut
(22) 30 to 40 INCH-POUNDS.
(1) Position de-ice wire harness (18) between
swashplate ends of link (1).
(2) Aline link (1) with swashplate (17).
(3) Install sleeve bushing (19) through swash-
plate (17) and link (1) and over harness (18).
(4) Install shear bolt (20) through washer (21),
swashplate (17), link (1), and sleeve bushing
(19).
(5) Check fit of self-retaining bolt (20) (para
11.1).
(6) Install self-locking nut (22). Torque nut (22) to
30 INCH-POUNDS. Use torque wrench.
(7) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(8) Install new cotter pin (23).
e. Install harness loop clamp (24) on links (1).
(1) Install screw (25) through washer (26), clamp
(24), sleeve spacer (27), link (1), sleeve
spacer (27), and bracket (7).
(2) Install washer (26) and self-locking nut (28).
GO TO NEXT PAGE
2219
17
1
23
M04-1769-3
20
21
18
M04-1769-9
28
26
25
24
27
1
7
26
27