TM 1-1520-238-23
Change 6
11-1167
11.276.
TAIL ROTOR ELECTRICAL LEAD REMOVAL/INSTALLATION – continued
11.276.3. Removal
NOTE
If lead will be replaced, remove clamps
from jumper.
a. Remove electrical lead (1) from vertical stabi-
lizer (2) and swashplate (3). Use maintenance
platform.
(1) Remove corrosion preventive compound
from lead terminal ends (4).
(2) Remove nut (5) and washer (6) from stud (7).
(3) Remove nut (8), washer (9), and screw (10)
from attach point on swashplate (3).
(4) Remove three nuts (11), screws (13), wash-
ers (12), and clamps (14) from brackets (15).
(5) Remove screw (16), spacers (17), and
clamps (18) and (19).
(6) Remove lead (1).
NOTE
Steps b. through d. apply to the remain-
ing leads outboard of the tail rotor swash-
plate.
b. Remove lead (20) from swashplate (3).
(1) Remove corrosion preventive compound
from lead terminal end (21).
(2) Remove nut (22), washer (23), and screw
(24).
GO TO NEXT PAGE
10
13
12
15
14
11
4
5
2
1
ROTATED 180º
3
1
4
3
2
1
8
9
ROTATED 90º
17
18
16
19
6
7
M04-3648-1
24
20
3
M04-3648-2
22
23
21
