TM 55-6930-214-10
(4) Reference numbers 10 and 11 are used to enter logical connectors. If more
than one parameter is to be associated with an event, then a logical connector
(AND, OR) must be designated for all but the last parameter. Reference numbers 10
and 11 are used for these connectors. When AND is used as a connector, all para-
meters connected with AND must be met to trigger the event. If OR is used as a
connector, any of the parameters connected by OR will trigger the event when it is
met.
(5) Reference number 101 is used to clear a line (e.g., 15 TAB 101 clears line
15). When a line which has other lines dependent on it is cleared, the dependent
lines are also cleared (e.g.. 16 TAB 101 clears lines, 16, 17. 18 and 19).
g. During TEE preparation functions, the edit area of the CRT page provides
operator prompts for data input and error messages for any out-of-range or invalid
entries. Numerical inputs via the keyboard are echoed in the edit area with a cur-
sor to indicate the next entry. When TAB is depressed between data fields, the
appropriate data input appears on the first line of the edit area (e.g., when 02
TAB is keyed in, the prompt appearing in the edit area states: ENTER TARGET TYPE
REFERENCE NUMBER). (Target type reference numbers are listed on the target types
list CRT page 951).
NOTE
If an error is made entering in data, an error message appears
in the edit area (e.g., ERROR - VALUE OUT OF RANGE). To correct
the error, depress the BACKSPACE or CLEAR keys to delete the
entry, then insert the correct data.
h. Table 7-14 indicates the procedure required to enter the worksheet data into
CRT page 950 and the prompts and data displayed in the edit area. In the entry
column are the numbers to be entered plus the appropriate action key (e.g., DISPL,
TAB, ENTER). The edit area displays column depicts three line entries to include
(Blank) when nothing is shown and a line (
) for the cursor mark. Lines 02
through 06 accommodate entries for MOTION, PATHWAY, and SPEED. Lines 07 through 11
have no MOTION prompts, so ENTER is keyed in after entering the IR code. After
entering all the targets (lines 02 through 11) for a TEE, the triggering contin-
gencies are then entered in lines 12 through 68. The procedure in table 7-14
completes the required entries for the first target type, site associated activity,
events, and two triggering contingencies. The process is repeated for each
additional target until the TEE prep page is complete.
Each time ENTER is keyed in. the data in line 3 of the edit area
blanks and the data appears on that numbered line in the main
page area of the prep page.
Change 2 7-169
