TB 1-1500-351-20-1
7.
Crimp the crimp ring using the crimping tool M22520/5-01 and die Y211. Solder the crimp ring to the
braids with rosin core tin solder or equivalent.
8.
Trim the cable core lush with the end of the transfer body. Be careful not to nick the center of the
cable conductor. Tin the center conductor with rosin-core tin alloy solder. Slide the rear dielectric with
the large diameter irst onto the center conductor. Put a .020" diameter x .040" long rosin-core tin alloy
solder slug into the center contact. Then slide the contact onto the center conductor and solder it in
place.
NOTE
For straight connectors only, place Telon gasket over the center connector.
9.
Apply Loctite 620 or equivalent to the threads of the transfer body and screw on the connector body.
Torque connector body and transfer body to 20 inch-pounds. Shrink the shrink tubing right behind the
connector body as shown. Shrink the white sleeve markers behind the shrink tubing for each end.
9
