TB 1-1520-238-20-135
8. SUPPLY KITS/PARTS AND DISPOSITION --
8.1 TB kits supplied by: PEO Aviation SFAE-AV-AAH-LF.
8.2 TB kits authorized only for: AVUM.
8.3 Bulk and Consumables:
NOMEMCLATURE
PART NUMBER
NSN
Paint, Red
EPB-4-230/D4
N/A
Lubricant, Solid Film
HMS4-1078
Corrosion Preventative Com-
MIL-C-16173*C2GR4
pound
Sealing Compound
MIL-S-81733
Sealing Compound (alt)
HMS16-1097*T2CB-1/2
8.4 Parts Disposition: Disposition of parts removed and not used during installation of this TB will be in
accordance with proper disposal procedures.
9. SPECIAL TOOLS, JIGS, TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE), AND
FIXTURES REQUIRED --
NOMEMCLATURE
PART NUMBER
Quantity
Milliohm meter
1
10. PROCEDURES --
WARNING
Use solid film lubricant only in well ventilated areas. Keep away from
flames or sparks. Harmful if inhaled. If injury occurs, seek medical
aid.
CAUTION
Ensure that a Foreign Object Damage (FOD) prevention program is
implemented during application of this TB in accordance with AR
385-95.
NOTE
Determine run-on torque by using a torque wrench and rotate the nut for a
minimum 180 degrees while observing the torque wrench reading. Ensure
the nut is not seated against the washer and at least one thread protrudes
past the nut. The resultant observed torque should be added to the ranges
listed in the task steps.
10.1 All threads shall be sprayed per HP4-75 or MIL-PRF-46417C, with a coat of HMS4-1078* Type 1
lubricant before installation.
CAUTION
Do not heat ferrous parts over 350 degrees F or nonferrous parts over
250 degrees F damage may result.
Do not cool bearings and bushings below -321 degrees F. Damage
may result.
3
