TB 1-1520-238-30-19
NOTE
Friction disk cavity may have a small amount of wetness due to static leak-
age and operation. Do not reject clutch for this condition.
7.6 Separate outlet housing (Figure 1, Detail A) and attached parts from inlet housing.
7.7 Install plastic cap (P/N VC-437-16) on the end of the clutch (12) output shaft.
7.8 Bag or cover input section of clutch (12) - store in a clean area on work bench with the APU side down.
CAUTION
Immediately wipe off clutch debris/grease film from the aft opening
and ID surface of the splined output adapter (19) before the aft protec-
tive plastic plug is installed. Ensure the roller bearing (20) is not con-
taminated when doing this.
7.9 Install plastic cap (P/N VC-812-16) into the inner diameter of the aft opening of the splined output
adapter (19) to protect roller bearing (20) from contamination.
7.10 Place splined output adapter holder (P/N 298171-1, Figure 3) in bench vice.
7.11 Place splined output adapter (19) of outlet housing assembly on splined output adapter holder. Using
punch (P/N 3210689-1, Figure 4), unstake nut (16). Apply direct pressure downward while unstaking nut to
avoid damaging threads.
7
