TB 1-1520-238-30-19
10.27 Center punch data plate at location shown in Figure 16 (Below the word "clutch") after each 125 hour
interim maintenance effort.
10.28 Install gasket (4) and dataplate (3) secure with washers (2) and screws (1).
10.29 Lightly coat bolts (6) and (7) with Liqui-Moly NV.
10.30 Install bolt (6) in alignment with the small nameplate and secure with nut (5).
10.31 Install bolts (7) at remaining locations and secure with nuts (5).
10.32 Install washer (9) against the housing, bolt (8) and ground strap terminal.
10.33 Using a calibrated torque wrench torque bolts to 50 inch-pounds.
10.34 Remove excess Hylomar compound from outside diameter of clutch assembly.
10.35 Complete Data Worksheet (Figure 17) and send to the Technical POC.
24
