TM 1-1520-238-10
4-68
Change 8
f. CPG ARM/SAFE – ARM.
g. Lase target or call for remote designator.
h. Observe AND or HIGH ACTION display for
missile system messages.
i. CPG WAS – MSL.
j. Pilot establish the helicopter in constraints.
k. Weapons trigger – Press and release.
l. Pilot establish helicopter in constraints.
m. Repeat steps j. thru l. until desired number
of missiles have been fired.
4. Ripple Mode – LOAL.
a. UPR/LWR CHAN CODE – As desired.
b. UPR/LWR CHAN QTY – As desired.
c. MSL MODE – RIPL.
d. CHAN SEL switch – Establish priority chan-
nel.
e. Observe AND or HIGH ACTION display for
missile selection, coding, ready status.
f. LOAL select switch – As desired.
g. CPG ARM/SAFE – ARM.
h. CPG WAS – MSL.
i. Pilot establish helicopter in constraints.
j. Weapons trigger – Press and release.
k. Pilot establish helicopter in constraints for
alternate channel.
l. Weapons trigger – Press and release.
m. Lase target or call for terminal guidance.
n. Execute steps i. thru m. until desired num-
ber of missiles have been fired.
b. Missile System Shutdown Procedures.
1. MSL MODE – STBY.
2. LOAL select switch – OFF.
3. CHAN SEL – Actuate either direction.
4. MSL switch – OFF.
4.34 ARMAMENT POSTFLIGHT PROCEDURES.
If armament system has been used, check as follows:
1. Right FAB – Open. Check carrier drive for
rounds.
2. Gun chute assembly – Check for rounds.
3. Bolt status indicator – FEED (green range).
4. Transfer door – Open. Check bolt is to rear, no
rounds in transfer assembly, and chamber clear.
5. Transfer door – Secure.
6. AWS – General condition and security. Check
for leaks and proper piston index groove indica-
tion.
7. Wing stores pylon – Check for unexpended ord-
nance.
