TM 1-1520-238-10
Change 9
8-7
b. TRANS switch OFF.
c. CROSSFEED switch NORM.
d. ENG 1 switch ON.
e. ENG 2 switch ON.
17. PWR levers OFF.
18. ENG START switch OFF.
*19. MASTER IGN switch Verify ON.
20. RTR BK OFF.
21. ELEC PWR panel switches Check switch
OFF.
22. STORES JETT select switches Guard covers
down.
23. ROCKETS control panel Set.
24. ECS control panel Set as follows:
a. ENCU ON.
b. FAN NORM.
c. TEMP control As desired.
25. TAIL WHEEL switch LOCK.
*26. CANOPY JETTISON pin Remove and stow.
27. ENG FIRE PULL handles In.
28. FIRE BTL select switch Centered.
29. FIRE CONTROL panel Set as follows:
a. SIGHT SEL switch STBY.
b. ACQ SEL switch OFF.
c. VID SEL switch PLT.
d. ACM switch OFF.
e. PNVS switch OFF.
f. IHADSS BRSIT switch OFF.
g. RKT select switch OFF.
h. GUN select switch OFF.
i. MSL select switch OFF.
30. Magnetic compass Check.
31. BRU Check.
32. Engine instrument test panel switch As de-
sired.
33. Flight instruments Check or set as follows:
a. Airspeed indicator.
b. Standby attitude indicator Cage.
c. VDU OFF.
d. Radar altimeter OFF.
e. Altimeter Check.
f. Vertical speed indicator.
g. HSI.
h. Stabilator position indicator and placard.
34. Clock Set.
35. Accelerometer Reset.
36. HARS OFF.
37. EMERG HYD switch OFF.
38. CSC panel switches As desired.
39. Right console avionics OFF. Set frequencies
as desired.
40. APU FIRE PULL handle In.
41. APU FIRE BTL select switch Centered.
8.12 INTERIOR CHECK CPG.
*1. Canopy door As desired.
*2. Loose equipment Secured.
3. Seat Adjusted to design eye position.
*4. Restraint harness Fastened and adjust.
NOTE
Routing the IHADSS HDU cable under the
right arm may cause entanglement during
emergency egress.