TM 1-1520-238-23
2-79
2.30.
KEVLAR REPAIR – continued
WARNING
Do not place heater near flammable
material or allow heater to contact
skin: severe burns can result. Wear
protective equipment. If injury occurs,
seek medical aid.
d. Complete repair.
(1) Tape cellophane covered support (15) to con-
form to original contour on inner side of fairing
behind hole (11). Use cellophane (item 41,
App F) and tape (item 205, App F).
(2) Place smaller cloth pieces (12) in hole (11)
against support (15). Place doubler (13) over
last cloth piece (12), then center two doublers
(14) over one another.
(3) Place cellophane (17) over patch (16) and
press into place. Remove all air pockets. Use
cellophane (item 41, App F).
(4) Remove cellophane (17) from patch (16).
(5) Apply a coat of adhesive over patch (16). Use
brush (item 34, App F) and adhesive (item 5,
App F).
(6) Cure patch (16) until surface is hard and tack-
free. Use heater.
(7) Remove support (15).
e. Inspect (QA).
GO TO NEXT PAGE
12
15
16
M04-2334-4
1314
17
11
