TM 1-1520-238-23
2-81
2.30.
KEVLAR REPAIR – continued
(3) Press cellophane (23) into place over patch
(24). Remove all air pockets. Use cellophane
(item 41, App F).
(4) Remove cellophane (23) from patch (24).
(5) Apply a coat of adhesive over patch (24). Use
brush (item 34, App F) and adhesive (item 5,
App F).
(6) Cure patch (24) until surface is hard and tack-
free. Use heater.
d. Inspect (QA).
2.30.6. Small Delaminated Areas
WARNING
Do not place heater near flammable
material or allow heater to contact
skin: severe burns can result. Wear
protective equipment. If injury occurs,
seek medical aid.
a. Repair small delaminated areas (25) under 2
INCHES long in any direction.
(1) Drill several small holes (26) into (not
through) delaminated areas (25).
(2) Inject adhesive into holes (26). Use syringe
(item 196, App F) and adhesive (item 5,
App F).
(3) Apply pressure on repaired area with backing
block (27).
(4) Remove backing block (27).
(5) Cure at 205 F (96 C) 45 MINUTES. Use
heater.
GO TO NEXT PAGE
M04-2334-6
24
23
25
26
27
M04-2334-7
