TM 1-1520-238-23
Change 2
2-327
2.91.
AFT RIGHT CENTER TRANSMISSION ROTOR SUPPORT STRUT ASSEMBLY
REMOVAL/INSTALLATION – continued
2.91.3. Removal
a. Remove fuel cross feed hose (1) and loop
clamps (2) and (3) from aft right center trans-
mission rotor support strut assembly (4).
(1) Hold screw (5). Remove self-locking nut (6)
and washer (7).
(2) Remove screw (5) from clamps (2) and (3).
(3) Remove hose (1) and clamps (2) and (3) from
strut (4).
b. Remove engine control cable bracket assem-
bly (8) from strut (4).
(1) Hold two screws (9). Remove self-locking
nuts (10) and washers (11).
(2) Remove two screws (9) and washers (12)
from loop clamp (13), spacer ring (14), and
bracket (8).
(3) Remove bracket (8) from strut (4).
WARNING
Apply tension to the maintenance
crane cable/lifting hook before remov-
ing strut. Failure to follow instructions
may result in serious injury or death to
maintenance personnel and/or seri-
ous damage to the helicopter. If injury
occurs, seek medical aid.
c. Remove strut (4) from transmission deck (15).
(1) Remove lockwire from bolt (16).
(2) Remove bolt (16) and recessed washer (17).
Use socket wrench and telescopic bar.
(3) Remove strut (4) from deck (15).
GO TO NEXT PAGE
2
M04-1466-5
4
1
6
5
3
7
M04-1466-6
9
8
13
10
11
13
4
12
14
M04-1466-7
M04-1466-8
16
17
15
4
