TM 1-1520-238-23
2-332
Change 2
2.92.
LEFT FORWARD SIDE TRANSMISSION ROTOR SUPPORT STRUT ASSEMBLY
REMOVAL/INSTALLATION – continued
2.92.3. Removal
a. Remove wire harness (1) from left forward
side transmission rotor support strut assem-
bly (2).
(1) Hold screw (3). Remove self-locking nut (4)
and washer (5).
(2) Remove screw (3) from loop clamp (6) and
two clamps (7) on wire harness.
(3) Remove harness (1) from strut (2).
WARNING
Apply tension to the maintenance
crane cable/lifting hook before remov-
ing strut. Failure to follow instructions
may result in serious injury or death to
maintenance personnel and/or seri-
ous damage to the helicopter. If injury
occurs, seek medical aid.
b. Remove engine control cables (8) from strut
(2).
(1) Hold screw (9). Remove self-locking nut (10)
and washer (11).
(2) Remove screw (9) and washers (12) and (13)
from engine control cable angle bracket (14)
and loop clamp (15).
(3) Remove cables (8) from strut (2).
c. Remove strut (2) from rotor support mast sup-
port base (16) and left aft side transmission
rotor support strut assembly (17).
(1) Remove and discard cotter pin (18).
(2) Hold bolt (19). Break torque on self-locking
nut (20). Use telescopic bar and adapter.
(3) Remove nut (20) and washer (21). Use
ratchet and 5-inch extension.
(4) Remove bolt (19) and washer (22) from strut
(2), base (16), and strut (17).
GO TO NEXT PAGE
4
7
6
5
3
1
2
M04-1468-2
M04-1468-3
2
15
14
12
9
8
10
11
13
17
16
22
2
20
18
M04-1468-4
19
21
