TM 1-1520-238-23
2-335
2.92.
LEFT FORWARD SIDE TRANSMISSION ROTOR SUPPORT STRUT ASSEMBLY
REMOVAL/INSTALLATION – continued
NOTE
Nut may be reused if run-on torque ex-
ceeds 50 INCH-POUNDS.
c. Install strut (2) on base (16) and strut (17).
Torque nut (20) 3360 to 3640 INCH-POUNDS.
(1) Aline strut (2) on base (16) and strut (17). Use
driftpin.
(2) Install bolt (19) and washer (22) in strut (2)
base (16), and strut (17).
(3) Hold bolt (19). Install washer (21) and nut
(20) on bolt (19) finger tight. Use box wrench.
(4) Ensure nut (20) has no less than 50 INCH-
POUNDS run-on torque. Use torque wrench.
(5) Hold bolt (19). Use box wrench.
(6) Torque nut (20) to 3360 INCH-POUNDS. Use
torque wrench, adapter, and 5-inch
extension.
(7) Increase torque to aline cotter pin hole, but do
not exceed 3640 INCH-POUNDS.
(8) Install cotter pin (18).
d. Install cables (8) on strut (2).
(1) Install screw (9) through washer (12), bracket
(14), clamp (15), and washer (13).
(2) Hold screw (9). Install washer (11) and nut
(10).
GO TO NEXT PAGE
22
2
M04-1468-8
19
20
16
21
17
M04-1468-9
19
16
20
18
M04-1468-11
9
12
14
15
2
8
13
10
11
