TM 1-1520-238-23
2-454.2
Change 6
2.126A. TAIL ROTOR DRIVE SHAFT FAIRING T355 REPAIR (AVIM) – continued
(4) Cut two chafe strips (3) conforming to outside
radius of fairing (1) and centered on hole (4).
Use rubber sheet (item 152A, App F).
(5) Cut 0.50 INCH radius hole centered in two
chafe strips (3) conforming to inside radius
and centered on hole (4).
(6) Trim two chafe strips (3) to 0.090 INCH thick.
(7) Clean two chafe strips (3) and bonding area
(5). Use methyl ethyl ketone (item 124,
App F).
(8) Apply adhesive to chafe strip (3). Use
adhesive (item 2, App F).
(9) Apply adhesive to bonding area (5). Use
adhesive (item 2, App F).
(10) Install chafe strip (3) on bonding area (5).
(11) Allow adhesive to cure at room temperature
for 24 HOURS.
(12) Remove excess adhesive. Use methyl ethyl
ketone (item 124, App F).
(13) Apply EMI coating (para 2.34).
(14) Install two fasteners (2) on fairing (1) (para
2.21).
b. Inspect (QA).
END OF TASK
2
1
M04-5127-2
0.50R
1
3
5
4
2
