TM 1-1520-238-23
5-275
5.63.
TAIL ROTOR FORK CLAMP AND LOCKING PLATE REMOVAL/INSTALLATION (AVIM) – continued
b. Install plates (1) and (2) on fork (3). Torque
screws (6) to 25 INCH-POUNDS.
(1) Position plates (1) and (2) on fork (3) so that
screw holes are alined with plates (7) and (8).
(2) Mark position of plates (1) and (2) on fork (3).
Use wax pencil (item 137, App F).
(3) Apply adhesive to mounting surface of plates
(1) and (2). Use adhesive (item 19, App F).
(4) Position and install plates (1) and (2) on fork
(3).
(5) Temporarily secure plates (1) and (2) with
tape until mounting hardware is installed. Use
tape (item 205, App F).
(6) Install four screws (6), washers (5), and nuts
(4).
(7) Torque screws (6) to 25 INCH-POUNDS. Use
torque wrench, screwdriver bit holder, and
screwdriver bit.
c. Remove tape and excess adhesive from fork
(3) (para 1.47).
d. Inspect (QA).
END OF TASK
3
5
5
4
2
1
6
6
4
8
7
M04-3824-6
