TM 1-1520-238-23
5-120
5.24.
MAIN ROTOR DAMPER ROD END REMOVAL/INSTALLATION – continued
5.24.6. Installation
a. Lubricate threads of rod end (1) and nut (10).
Use lubricant (item 114, App F).
(1) Allow lubricated hardware to cure for 6
HOURS at room temperature, or air dry for 30
MINUTES and then cure for 30 MINUTES at
150 F (66 C).
b. Install rod end (1) in damper (9).
NOTE
Install nut same number of threads as
was removed in paragraph 5.24.3.
(1) Install nut (10), washer (12), and key washer
(11) on rod end (1).
(2) Screw rod end (1) in damper (9).
c. Aline rod end (1) with link (2) by adjusting nut
(10) until bolt (3) can be installed and removed
freely.
d. Lubricate threads of bolt (3) and new nut (4).
Use lubricant (item 114, App F).
(1) Allow lubricated hardware to cure for 6
HOURS at room temperature, or air dry for 30
MINUTES and then cure for 30 MINUTES at
150 F (66 C).
GO TO NEXT PAGE
M04-218-6
1
1012
11
9
2
3
2
4
1
M04-218-5
10
