TM 1-1520-238-23
7-418
7.112.
HYDRAULIC ADAPTER REPLACEMENT continued
7.112.3. Removal
a. Clean excess primer from lockring (1) (para
1.47).
b. Unseat lockring (1) from port (2).
(1) Install lockring removal tool (3) on adapter
(4).
(2) Retract sleeve (5) until pin (6) bottoms in slot
(7).
(3) Place puller halves (8) over adapter (4) into
lockring groove (9).
(4) Slide sleeve (5) down over puller halves (8).
NOTE
Ensure proper engagement of puller
halves in lockring groove.
(5) Hold sleeve (5). Turn bolt (10) clockwise to
unseat lockring (1) from port (2). Use applica-
ble open-end wrench. Refer to table 1.
(6) Stop turning bolt (10) when external serra-
tions of lockring (1) are clear from surface of
port (2).
(7) Remove lockring removal tool (3).
c. Remove adapter (4) from port (2).
(1) Install combination tool (11) over adapter (4)
and engage serrations of tool (11) and lock-
ring (1).
(2) Remove adapter (4) from port (2). Use appli-
cable socket. Refer to table 1.
(3) Discard adapter (4), lockring (1), and packing
(12).
GO TO NEXT PAGE
M04-2670-1
1
M04-2670-2
2
5
7
6
8
4
1
9
10
3
M04-2670-3
11
2
4
1
M04-2670-4
12
1
4