TM 1-1520-238-23
7-421
7.112.
HYDRAULIC ADAPTER REPLACEMENT – continued
CAUTION
Ensure that lockring and port serra-
tions are alined prior to seating lock-
ring into port. Failure to observe can
result in damage to parts and failure of
equipment.
Any sudden increase in resistance on
combination tool prior to tool bottom-
ing on port surface, may indicate that
the lockring serrations and the port
serrations are not alined. If this occurs,
stop procedure to prevent damage to
parts. Repeat applicable steps to en-
sure serrations of lockring and port are
properly alined.
To prevent port damage, do not contin-
ue turning combination tool once tool
has bottomed on surface of port.
d. Seat lockring (1) into port (2).
(1) Apply epoxy primer on bottom of lockring (1)
and down into port (2). Use epoxy primer
coating kit (item 78, App F) and brush
(item 34, App F).
(2) Install combination tool (11) on threads of
adapter (4) until tool (11) touches lockring (1).
NOTE
Seat lockring while primer is still wet.
(3) Turn combination tool (11) clockwise until
lockring (1) seats down into port (2) and tool
has bottomed on surface of port (2). Use ap-
plicable socket. Refer to table 1.
(4) Wipe excess epoxy primer from lockring (1)
and surface of port (2).
GO TO NEXT PAGE
M04-2670-7
11
2
4
1
