TM 1-1520-238-23
6-132
6.27.
ENGINE NOSE GEARBOX IDENTIFICATION PLATE REPLACEMENT – continued
6.27.5. Inspection
NOTE
The following inspection procedures ap-
ply to identification plate mounting area on
engine nose gearbox housing.
a. Check for cracks. None allowed.
b. Check for corrosion (para 1.49).
c. Check for scratches, nicks, and gouges (para
6.17).
6.27.6. Installation
a. Transcribe recorded data on new plate (1).
Use die set.
b. Install plate (1) on gearbox (2).
(1) Remove lining from mounting surface of plate
(1).
(2) Lightly abrade mounting surface of plate (1).
Use cloth (item 48, App F).
(3) Apply a thin, uniform coat of adhesive to
mounting surface of plate (1). Use brush
(item 34, App F) and adhesive (item 13,
App F).
(4) Position and install plate (1) on gearbox (2) in
same location as old plate.
(5) Seal edges of plate (1). Use adhesive
(item 13, App F).
c. Inspect (QA).
d. Install engine nose gearbox fairings and
shrouds (para 2.123).
END OF TASK
M04-3788-3
1
2
M04-3788-4
1
2
ADHESIVE
EDGE-SEAL
